Z3 counter, where's my hours ?

[sirblurr]

Really annoying, but probably pretty simple / obvious, where can i read the amount of lamp hours i have used on my Sanyo PLV Z3. I can see where to reset the lamp but not the amount of hours used. Can't find info in the destructions either!!??

 

[spooney]

Assuming the menu has not changed too much with the Z4 it should be in the info panel where it shows frequency input type and lamp hours.

 

[Benrudd1]

Hi,

Make sure the projector is set to need 2 pushes of the power button to switch off,
then with the projector switched on hold the power button on the projector itself down for over 20 seconds and an hours used display should pop up in the top left hand side of the screen

Hope this helps

 

[sirblurr]

Sorted. Thanks.

 

[museumsteve]

Hi,

Make sure the projector is set to need 2 pushes of the power button to switch off,
then with the projector switched on hold the power button on the projector itself down for over 20 seconds and an hours used display should pop up in the top left hand side of the screen

Hope this helps

thanks mate..I just picked up a really cheap Sanyo XU41 and couldn't find the hours...this worked a treat