Murph76
Standard Member
Hi all, little bit of a kink I hoped someone could pitch in on. I have run a new calibration to setup up on my full 15.1 setup, just added the two wides.
Calibration went as expected. Chose the Atmos narrow preset during speaker selection. Set my target curve and all sound good. Problem is that 2D and 3D remap does not appear to be working. When I am inputing multichannel music via roon with with remap enabled only 5.1 speakers are being utilised, due to imperfect placement I would expect rear surrounds and at least one of the wides would be employed to get the correct sound stage. This is also happening in movies. Hence center sounds low down and is very obviously not getting the elevation effect from the other speakers.
Has onyone else encountered this before?
I don't think that I changed anything to cause this to happen. I did try a reboot etc.
Thanks in advance
Calibration went as expected. Chose the Atmos narrow preset during speaker selection. Set my target curve and all sound good. Problem is that 2D and 3D remap does not appear to be working. When I am inputing multichannel music via roon with with remap enabled only 5.1 speakers are being utilised, due to imperfect placement I would expect rear surrounds and at least one of the wides would be employed to get the correct sound stage. This is also happening in movies. Hence center sounds low down and is very obviously not getting the elevation effect from the other speakers.
Has onyone else encountered this before?
I don't think that I changed anything to cause this to happen. I did try a reboot etc.
Thanks in advance