Technical help: How to get Oculus Home running on DK2

Discussion in 'VR Virtual Reality Forum' started by oasismark, Jun 23, 2016.

  1. oasismark

    oasismark
    Distinguished Member

    Joined:
    Jun 1, 2006
    Messages:
    13,622
    Products Owned:
    0
    Products Wanted:
    0
    Trophy Points:
    166
    Location:
    Sheffield
    Ratings:
    +3,700
    Hello all,

    Im not very technical, so after some advice, i have a DK2 and ive had it running on a laptop. with the old DK2 SDK. I had it set up, the demo scene works, Virtual Desktop works and a few demos work.

    But i cannot get Oculus Home working at all?

    I presume it is compatible as ive seen many videos on you tube etc.

    I understand you have to remove all traces of the old DK2 stuff, then just run the new Oculus install software.

    I do this but when i run the set up it goes straight to 'Carry on in your headset' how can i stop it going direct to this?

    Also what setting should i have in the Screen options? Resolution, portrait, duplicate or extend etc.

    Sorry for the newb questions, i just want to run Oculus Home on a DK2, cant be that impossible
     
  2. oasismark

    oasismark
    Distinguished Member

    Joined:
    Jun 1, 2006
    Messages:
    13,622
    Products Owned:
    0
    Products Wanted:
    0
    Trophy Points:
    166
    Location:
    Sheffield
    Ratings:
    +3,700
    Ignore all this, i think its the laptop thats not up to spec..


    Actually 1 quick question:

    If the specs are lower than whats recommended, will it just not flat work at all, or will it work with low frames per second or something
     
    Last edited: Jun 23, 2016

Share This Page

Loading...
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice