SVGA CABLES for a rgb to plasma vga box

Discussion in 'Plasma TVs Forum' started by dfh28, Dec 2, 2002.

  1. dfh28

    dfh28
    Guest

    Products Owned:
    0
    Products Wanted:
    0
    Ratings:
    +0
    Can anyone recommend suppliers for these cables

    I will be conecting a panasonic TH50PHW5B and will be needing a good quality 5m cable.

    Also can anyone tell me what ends have to be on the cable.

    Many Thanks
     
  2. symanski

    symanski
    Active Member

    Joined:
    Jun 20, 2002
    Messages:
    874
    Products Owned:
    0
    Products Wanted:
    0
    Trophy Points:
    18
    Location:
    Scotland
    Ratings:
    +8
    15-pin High Density male connectors.

    Ensure that the cables are built from high quality co-ax cable, with an impedance of 75 ohms. 5m is not a problem. What's important is that you're now using the right signal, then you start to look at cables for smaller improvements.

    All the best,

    Dr John Sim.
     

Share This Page

Loading...
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice