Studio 8 Make Video Cannot initialise ?

Discussion in 'Camcorders, Action Cams & Video Making Forum' started by brado, May 27, 2004.

  1. brado

    brado
    Standard Member

    Joined:
    Jan 16, 2004
    Messages:
    130
    Products Owned:
    0
    Products Wanted:
    0
    Trophy Points:
    16
    Location:
    Worcester UK
    Ratings:
    +0
    After updating the bios on my ASUS board and my Nvidea graphics card, I now I can get as far as creating a video to tape. I will go no further because it cannot find the DV equipment, which is my camera, connected and switched on to standby. This had worked before I updated to cure another problem
    Next I tried making an AVI file first, which was OK. I then tried to make a tape from that, but with the same end result.

    I am using the latest update to Studio 8 :( :(

    Has anyone any ideas what could be causing this?
    Thanks
     
  2. brado

    brado
    Standard Member

    Joined:
    Jan 16, 2004
    Messages:
    130
    Products Owned:
    0
    Products Wanted:
    0
    Trophy Points:
    16
    Location:
    Worcester UK
    Ratings:
    +0
    I discovered I had not updated to 8.12.7 after the reinstall of my 8.3 v.
    Now everything is perfect :clap:
     

Share This Page

Loading...
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice