Sony Av3000, X10 and a macro

Discussion in 'Home Cinema Control & Remote Controls' started by vicbarry, Oct 20, 2003.

  1. vicbarry

    Active Member

    Oct 13, 2003
    Products Owned:
    Products Wanted:
    Trophy Points:
    Hi gang. Greetings from Cork, Ireland.

    I have X10 lighting in my theater. Works fine with my Av3000. Channel buttons dim + and - which is fine.

    What i want to do is create a macro that dims all the lights (say system 2) and create another macro (say system 3) that brightens them back up. Or could i assign them to the scenes in lighting.

    What i have tried so far is a macro with the Channel - keys but it takes loads of presses and doesnt get very far. I have tried the interval times and the times but to no avail. It might get to 50% brightness after a while. While if i keep the Channel - pressed it goes down in no time.

    Is there a way to do this, or is it impossible. Help, this is driving me mad.

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice