Sharpness and Hue on BD808s?

Discussion in 'Projectors, Screens & Video Processors' started by cj, Aug 11, 2003.

  1. cj

    cj
    Active Member

    Joined:
    Apr 6, 2001
    Messages:
    1,471
    Products Owned:
    1
    Products Wanted:
    0
    Trophy Points:
    51
    Location:
    Reading
    Ratings:
    +74
    I know this is a bit of a noob question, but why do the Sharpness and Hue button on my BD808s remote not do anything? Are they supported on any Barco models?
     
  2. RichardA

    RichardA
    Guest

    Products Owned:
    0
    Products Wanted:
    0
    Ratings:
    +0
    cj,

    I think you'll find that they apply to certain input types only.

    Certainly the Hue control will only have an effect on a Composite NTSC source.

    I'm guessing (and hoping) that you are using a signal better than NTSC so it won't work in your installation.


    hope this helps!
     
  3. cj

    cj
    Active Member

    Joined:
    Apr 6, 2001
    Messages:
    1,471
    Products Owned:
    1
    Products Wanted:
    0
    Trophy Points:
    51
    Location:
    Reading
    Ratings:
    +74
    Ah now I see. Yes I'm using a component output from a TMA PSM192 module. Thanks.
     
  4. Roland @ B4

    Roland @ B4
    Active Member

    Joined:
    Apr 11, 2001
    Messages:
    2,238
    Products Owned:
    0
    Products Wanted:
    0
    Trophy Points:
    51
    Location:
    Reading.
    Ratings:
    +32
    They will only work when the signal goes through the projectors decoder. So composite, s-video or component. You are sending it an RGB signal. therefor bypassing its decoder.
     

Share This Page

Loading...
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice