Seleco 500 Setup

Discussion in 'Projectors, Screens & Video Processors' started by Edgeyboy, Mar 17, 2001.

  1. Edgeyboy

    Edgeyboy
    Well-known Member

    Joined:
    Jul 31, 2000
    Messages:
    3,497
    Products Owned:
    0
    Products Wanted:
    1
    Trophy Points:
    86
    Location:
    Norfolk
    Ratings:
    +168
    I have a query regarding the installation / setup of a Seleco 500 CRT that I have boguth recently:

    The projector is ceiling mounted. The ceiling is low (2m) and the image is too far down the wall with the top of the projector dead level. The situation is made worse as the centre speaker is below the screen so is very (too) near the floor.

    I know you can move the image electronically up and down using the deflection, but I believe it is not good to run these at high values permanently.

    So... Can i tilt it up very slighlt to bring the image up by 2-3". The screen is a 6FT wide 16:9 ratio.

    Thanks
     
  2. Chris Frost

    Chris Frost
    Well-known Member

    Joined:
    Jul 14, 2000
    Messages:
    2,782
    Products Owned:
    0
    Products Wanted:
    0
    Trophy Points:
    86
    Location:
    Cheshire
    Ratings:
    +109
    Yes

    ------------------
    Chris Frost
    Regional Sales Manager-N.England & Scotland
    Owl Video Systems Ltd
    www.owl-video.co.uk
     

Share This Page

Loading...
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice