I IRTI Novice Member Joined Jan 10, 2016 Messages 7 Reaction score 2 Points 1 Age 39 Location England Jan 10, 2016 #1 I recently picked up a Seleco 350 projector but I am having a few problems in getting the blue lined up with the Red and Green. Any ideas what would cause the blue line to bend like this? Attachments DSC_0364.JPG 825.3 KB · Views: 39
I recently picked up a Seleco 350 projector but I am having a few problems in getting the blue lined up with the Red and Green. Any ideas what would cause the blue line to bend like this?
Wull Prominent Member Joined May 19, 2009 Messages 4,289 Reaction score 904 Points 812 Age 55 Location gateway to the lakes Jan 11, 2016 #2 It's been a while. I would reset all the convergence trims to zero. Carry out the mechanical centering of the tubes, as explained on page 53. http://www.curtpalme.com/docs/Seleco310_350_Install_User.pdf Here an old thread that may give you some tips? Seleco svp350 manual Good luck!!
It's been a while. I would reset all the convergence trims to zero. Carry out the mechanical centering of the tubes, as explained on page 53. http://www.curtpalme.com/docs/Seleco310_350_Install_User.pdf Here an old thread that may give you some tips? Seleco svp350 manual Good luck!!
I IRTI Novice Member Joined Jan 10, 2016 Messages 7 Reaction score 2 Points 1 Age 39 Location England Jan 11, 2016 #3 Thanks! I think I nailed this, it was the red screws on the top of the projector that needed tuning in rather than moving the actual lenses. I almost have lightgun games working on it now.
Thanks! I think I nailed this, it was the red screws on the top of the projector that needed tuning in rather than moving the actual lenses. I almost have lightgun games working on it now.