Screws for thermal blocks-ok its been asked before!

Discussion in 'Plasma TVs Forum' started by birdseed, Oct 1, 2005.

  1. birdseed

    Active Member

    Nov 17, 2004
    Products Owned:
    Products Wanted:
    Trophy Points:
    Hi all,

    About to mount my pio 436 onto my wall. Since discovered there is a 25mm gap from the front of the plaster to the thermal blocks. the plaster is 10mm of this. there dont appear to be any wooden battons, so i assume theres dabs of plaster which i can percuss out.

    A colleague suggested chemical anchors, but homebase dont sell them, and given the 25mm gap, id feel better with a 120mm screw to stop the leverage.

    I also plan to move house in the next year so dont want to use the mdf/plywood panel direct onto the thermal block routine. Even putting battons in would destroy some plasterboard.

    Which fixings have people used successfully, or more interestingly unsuccessfuly in this situation.

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice