SCreenplay 4805 thread size for 3 holes for ceiling mount...

Discussion in 'Projectors, Screens & Video Processors' started by john<|>nhoj, Apr 14, 2005.

  1. john<|>nhoj

    john<|>nhoj
    Guest

    Products Owned:
    0
    Products Wanted:
    0
    Ratings:
    +0
    I am just about to mount my 4805 in a wall mounted box upside down, unfortunately I need the thread size which is a wierd one to mount the projector on the shelf upside down.

    I have worked it out that it is 3.5mm but some wierd pitch not available in B&Q and need either studding (threaded rod) or long bolts as it will fit a IKEA LACK Unit on the wall and this is ~50mm wide.

    HELP...
     
  2. dooby44

    dooby44
    Guest

    Products Owned:
    0
    Products Wanted:
    0
    Ratings:
    +0
    They are standard M4 bolts, the same as used in electrical sockets to hold the cover on.
     
  3. binbag

    binbag
    Active Member

    Joined:
    Jun 16, 2004
    Messages:
    1,717
    Products Owned:
    0
    Products Wanted:
    0
    Trophy Points:
    51
    Location:
    North Kent Coast, SE UK
    Ratings:
    +81
    Make sure that you don't go 'in' over 10mm either - theres a circuit board underneath.
     

Share This Page

Loading...
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice