1. Join Now

    AVForums.com uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Sanyo Z2 High Fan Noise

Discussion in 'Projectors, Screens & Video Processors' started by kunter, Jan 3, 2005.

  1. kunter

    kunter
    Guest

    Products Owned:
    0
    Products Wanted:
    0
    Ratings:
    +0
    Hi.

    I recently purchased a Z2 and I am quite happy with the performance. However there is a small problem I could not resolve.

    No matter what the lamp mode is, after about 15 minutes of projection, the fan starts at a very high speed. This is much higher than the full lamp mode. If at that point, I play with the lamp setting, the noise is back at the respective level.

    The projector sits on a shelf, nothing on the sides and top, and almost 20 cm from the back wall.

    Any comments will be appreciated.

    KK
     
  2. mr ooops

    mr ooops
    Member

    Joined:
    Mar 4, 2003
    Messages:
    3,592
    Products Owned:
    0
    Products Wanted:
    0
    Trophy Points:
    103
    Location:
    Hardwicke and Wotton
    Ratings:
    +353
    Had exactly the same problem, all be it mine was after 60 minutes use, making my front room cooler solved this problem, also 20cm may be to close and will hamper ventilation and will make the unit run hot, im sure i read in the manual it needs 50cm at the rear.

    hope this help
    jason
     

Share This Page

Loading...