Question Samsung LE40M87BD Keeps changing channel when Blu-Ray switched off!

Discussion in 'Samsung TVs Forum' started by rpartis, Jul 17, 2015.

Tags:
  1. rpartis

    rpartis
    Standard Member

    Joined:
    Apr 3, 2004
    Messages:
    9
    Products Owned:
    0
    Products Wanted:
    0
    Trophy Points:
    1
    Location:
    Wombourne
    Ratings:
    +0
    Hi All

    I know this an old TV but if anyone still has one I would appreciate any advice. Ive recently bought a Samsung BD6500 Blu-Ray player.

    This player and my SKY HD box are connected to an ONKYO TX-NR807 Amp via HDMI. So 2 HDMI in to the amp and 1 HDMI out to the Samsung TV.

    As a result the Samsung TV is of course set to the HDMI 1 input.

    Everything works as it should right up to the point where i finish watching a Blu-Ray and using the remote, power off the Blu-Ray player. At this point the TV says "Disconnecting Anynet+ Device Connection" then changes channel to the terrestrial input - i.e. BBC2 - which is just "snow" because i don't have an arial connected only SKY via HDMI. I then have to cycle back through the inputs on the TV to get back to HDMI 1 to find SKY again.

    Its a bit of a pain - is there any way to stop this ?

    Thanks
    Rob
     

Share This Page

Loading...