1. Join Now

    AVForums.com uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Rotel RB 1066 - 5 channel operation

Discussion in 'AV Pre-Amp/Processors & Power Amps' started by grey torq, Oct 15, 2004.

  1. grey torq

    grey torq
    Active Member

    Joined:
    Jul 13, 2002
    Messages:
    394
    Products Owned:
    0
    Products Wanted:
    0
    Trophy Points:
    28
    Ratings:
    +26
    Hi,

    Probably displaying my ignorance but the descriptive blurb for this 6x60w amp refers to 5x70w operation. I can see no reference to this in the manual, is it simply the case that if you operate it in 6 channel mode but only connect 5 i/ps and 5 sets of speakers you automatically get this 5x70w effect?

    I am going to use it to drive 4 rear surrounds and a front centre but do not want to bridge the centre channel as the speaker is rated at 6ohm probably based on a 4 ohm design. I'm also not keen on the distortion bridging introduces.

    Would I get 5x70w?

    Thanks

    Torq
     

Share This Page

Loading...