rel q100e

Discussion in 'Subwoofers' started by krusty, Mar 9, 2005.

  1. krusty

    krusty
    Guest

    Products Owned:
    0
    Products Wanted:
    0
    Ratings:
    +0
    quicky here..........how can i connect the rel to a yamaha amp do i need to use a splitter cable?or can i use that neutrik lead thing that comes with it?
     
  2. Stellavision

    Stellavision
    Active Member

    Joined:
    Apr 7, 2003
    Messages:
    2,489
    Products Owned:
    0
    Products Wanted:
    0
    Trophy Points:
    66
    Location:
    Portsmouth, UK
    Ratings:
    +145
    A single RCA cable to either of the sub outs will be fine.
     
  3. krusty

    krusty
    Guest

    Products Owned:
    0
    Products Wanted:
    0
    Ratings:
    +0
    thanks... i did actualy have to use a splitter for my velodyne vx10 for the left and right socket on the sub to the amp....how come i can get away with just using either the red or white on the rel? i presume its a mono single from a sub anyway? :lease:
     
  4. Stellavision

    Stellavision
    Active Member

    Joined:
    Apr 7, 2003
    Messages:
    2,489
    Products Owned:
    0
    Products Wanted:
    0
    Trophy Points:
    66
    Location:
    Portsmouth, UK
    Ratings:
    +145
    Yes, subs are only mono. The velodyne should also work fine without a splitter. I have known some sub manufacturers reccommend using a splitter, but the only gains to be had are usually allowing a slightly greater signal into the sub. This is mainly useful if you have a problem with auto on/off and the double inputs allow the sub to sense the signal easier.
     
  5. krusty

    krusty
    Guest

    Products Owned:
    0
    Products Wanted:
    0
    Ratings:
    +0
    the main reason i used the splitter on the velodyne was down to the problem it had sesing the signal......dont expect the rel to give me the same problem[ well i hope not]
     

Share This Page

Loading...