Had a programme in the planner set to record this evening. Put the box in standby and watched a DVD
At the end of the DVD, I turned on the sky box while it was recording and flicked to another channel. Where I got an error message cant remember exactly but said something about the signal.
Took a look in services, signal test where both channels were locked in and signal strength looked good.
However my Input1 Network ID was 0000 and Input1 Transport Stream was 0000
Normally these are Input1 Network ID 0002, Input1 Transport Stream 07d4
Recording was good, but until it finished I could only see the channel I was recording. Anyone know what went wrong?
At the end of the DVD, I turned on the sky box while it was recording and flicked to another channel. Where I got an error message cant remember exactly but said something about the signal.
Took a look in services, signal test where both channels were locked in and signal strength looked good.
However my Input1 Network ID was 0000 and Input1 Transport Stream was 0000
Normally these are Input1 Network ID 0002, Input1 Transport Stream 07d4
Recording was good, but until it finished I could only see the channel I was recording. Anyone know what went wrong?