Re-setting the Panny PW6 Remote

Discussion in 'Plasma TVs Forum' started by vblue, Dec 16, 2004.

  1. vblue

    vblue
    Guest

    Products Owned:
    0
    Products Wanted:
    0
    Ratings:
    +0
    Was using the remote on my PW6 to check how many hours the screen had been on for, but it now doesn't work, the LED still flashes so it's doing something, just not what I want! :confused:

    Does anyone know how I reset the remote, or re-programme it?

    Thanks
     
  2. reckless

    reckless
    Active Member

    Joined:
    Dec 21, 2003
    Messages:
    987
    Products Owned:
    0
    Products Wanted:
    0
    Trophy Points:
    28
    Ratings:
    +30
    I'm not an expert but I think I'd take the batteries out and then put them back in.
     
  3. hornydragon

    hornydragon
    Well-known Member

    Joined:
    Dec 19, 2001
    Messages:
    28,346
    Products Owned:
    0
    Products Wanted:
    0
    Trophy Points:
    136
    Location:
    Somewhere near the M4 most of the time......
    Ratings:
    +1,218
    ah i think you may have turned IR commends off (why untrained peeps should not be in service menu) Need a dealer with a laptop and RS232 control protocols to reset option IIRC there may be a factory reset for the panel to set to shipping state but dont know what it is...
     

Share This Page

Loading...
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice