1. Join Now

    AVForums.com uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Pronto RU940 Problem

Discussion in 'Home Cinema Control & Remote Controls' started by booktrunk, Sep 9, 2004.

  1. booktrunk

    booktrunk
    Banned

    Joined:
    Feb 6, 2004
    Messages:
    602
    Products Owned:
    0
    Products Wanted:
    0
    Trophy Points:
    18
    Location:
    Leicestershire
    Ratings:
    +3
    Hiya,

    I went about six months without using my pronto.

    So I finally decided to get off my arse and configure it again, so anyway did all that, stuck some new batteries into the pronto uploaded from the software and arrrrgh!!

    The display doesn't work the backlight comes on. If I move the contrast wheel the whole screen goes dark or light, BUT I just cannot see anything on the display.

    If I take the batteries out and put them back in I get the same just nothing on the display. If I guess where the buttons are correctly then I can press them and they actually function fine. So it works it's just I cannot see anything.

    Anyone got any ideas?

    Cheers

    Steff
     
  2. SimonO

    SimonO
    Active Member

    Joined:
    Nov 4, 2002
    Messages:
    3,193
    Products Owned:
    0
    Products Wanted:
    0
    Trophy Points:
    71
    Location:
    Hertfordshire
    Ratings:
    +64
    Try pressing the reset button on the bottom of the unit...
     

Share This Page

Loading...