Projector freezing while locking on a source signal

Discussion in 'Projectors, Screens & Video Processors' started by crion, Sep 19, 2004.

  1. crion

    Standard Member

    Jun 6, 2004
    Products Owned:
    Products Wanted:
    Trophy Points:
    Hi, I've had a Sim2HT300Plus for almost 2 years now, but today my pj started acting weird. When I try to view sources on my RI2 it changes to the input RGBS 15KHz for example, small info box goes blue and then the projector is in freeze mode and I can't do anything except turn it off on the backpanel. I'm running 2.36 firmware and I have never experienced this before. I also tried the DVI input and it works if I power up the projector with it, but if I change resolution like going from 1280*[email protected] to 1280*[email protected] the screen just go black and I can't do anything except turn it off on the backpanel.

    Anyone else had an experience like this? I will contact my dealer on monday for a repair as it should be covered by warranty.

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice