Projected image a wee bit squint-any suggestions?

[Ewan154]

Hi,
Think I finally have my PJ sqaure to the screen (or not far off In some scenes the images looks alittle squint.



http://imageshack.us/photo/my-images/12/p1010113iu.jpg/

http://imageshack.us/photo/my-images/593/p1010121e.jpg/

http://imageshack.us/photo/my-images/835/p1010131b.jpg/

http://imageshack.us/photo/my-images/69/p1010140vs.jpg/

http://imageshack.us/photo/my-images/62/p1010125ea.jpg/

 

[ard126k]

In the pic with the pattern on screen it looks like you could maybe go a gnat's to the left but that could be from the RH screen frame obscuring a bit.
If you want to be super-accurate you could measure the unlit areas of the screen and compare side to side and top to bottom but I'd be quite pleased with what you've done.
Alex.

 

[Ewan154]

Hi,
Thanks for the reply. If I measured from the left side of the PJ to the screen and then measured the done the same on the right side-would that tell me if one side of the PJ is nearer the screen than the other?

The right side of the screen is about a mm higher than the left side.

 

[ard126k]

No, I meant measure where the image lands on the screen.
Alex.