Question problems connecting Cubox i4 to HDQ

Discussion in 'Projectors, Screens & Video Processors' started by sharper, Jun 23, 2015.

  1. sharper

    sharper
    Active Member

    Joined:
    Jul 24, 2002
    Messages:
    614
    Products Owned:
    0
    Products Wanted:
    0
    Trophy Points:
    21
    Location:
    SW London
    Ratings:
    +11
    Cubox i4 (running Openelec) > Hdmi to DVi > Lumagen HDQ > Panasonic TH-50PH9

    I'm trying to get a stable connection between a Cubox i4Pro and HDQ. Now, I'm no expert on the HDQ, but have managed, mainly through trial and error, to get a stable picture from the cubox and save the setting on the corresponding input on the HDQ. I have the Cubox on a remote control mains socket as the Cubox is 'always on' by design and it enables me to switch it off when not in use (I'm disabled and it saves hassle). When I switch it back on and go to view via the Lumagen "no signal on input 2". If I reboot the Cubox, I 'sometimes' get a distorted picture and have to go through trying to attempt to set up input/output 2 all over again. Currently I am stumped....

    Any help or input would be greatfully received.

    All the best
    Stephen H
     

Share This Page

Loading...