Problem with DVDO VP30. Any help is appreciated!

Discussion in 'Projectors, Screens & Video Processors' started by alexkrich, Jan 14, 2008.

  1. alexkrich

    alexkrich
    Standard Member

    Joined:
    Jan 13, 2008
    Messages:
    4
    Products Owned:
    0
    Products Wanted:
    0
    Trophy Points:
    1
    Ratings:
    +0
    Hello everyone :)

    I had my DVDO VP30 for over 2 years now and it's been perfect. Two days ago, all the sudden, it stopped working. Instead, it is going through the start-up cycle when it displays DVDO and Anchor Bay's logos over and over again. The LED indicator is blinking red.
    I've tried to do a reset by disconnecting power and plugging it back while holding Menu and Exit buttons (as per the manual) but it didn't help.
    I though of updating the software but I can not switch the unit into the "communication" mode.
    Somehow I need to break this infinite start-up loop.
    Any suggestions?
    Thanks in advance!
     
  2. choddo2006

    choddo2006
    Well-known Member

    Joined:
    Dec 30, 2005
    Messages:
    8,528
    Products Owned:
    0
    Products Wanted:
    0
    Trophy Points:
    136
    Ratings:
    +542
    I would be getting hold of support @ DVDO matey
     

Share This Page

Loading...