Dismiss Notice
Attention AVForums app / Tapatalk users
Sadly GDPR means that, from 25th, we can no longer offer access to AVForums via the branded app or Tapatalk.
Click here for more information.

Pre-cabling a wall ready for PW6

Discussion in 'Plasma TVs Forum' started by cebs_uk, Sep 29, 2004.

  1. cebs_uk

    cebs_uk
    Well-known Member

    Joined:
    Jan 25, 2004
    Messages:
    2,537
    Products Owned:
    0
    Products Wanted:
    1
    Trophy Points:
    106
    Location:
    Manchester
    Ratings:
    +406
    Hi

    Just wondered if I could get a few views on the correct cable run for the PW6 while my walls are stripped and getting channels dug out.

    I figured on the following :

    1. Power
    2. VGA d-sub
    3. 5X BNC lengths for RGBHV or VUY or composite.

    and then the dvi/hdmi stuff :

    4. Just Dvi cable for the PW6s board.

    or

    4. HDMI cable or the future.

    With either option there are convertors out there that I hope would be compatible for example : on the denon 3910 come out pal/50hz on hdmi then covert to a dvi cable to go into the patch panel.

    Or should I just stick a length of each in and use an adapter at the plasma end if needed ?

    Thanks in advance

    Cebs
     

Share This Page

Loading...
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice