Philips 9966/10 how to run component to DVI?

Discussion in 'Philips TVs Forum' started by swedey, Nov 6, 2005.

Tags:
  1. swedey

    swedey
    Guest

    Products Owned:
    0
    Products Wanted:
    0
    Ratings:
    +0
    Hi, I have a Philips pf329966/10 and a JVC DR-M1. I am currently connected with scart. I wish however to run component out from the JVC through the adapter to DVI.
    When I do this I only get the message "Picture format not available". Can anyone tell me what I am doing wrong?
     
  2. Phill_1981

    Phill_1981
    Active Member

    Joined:
    Feb 14, 2005
    Messages:
    1,574
    Products Owned:
    0
    Products Wanted:
    0
    Trophy Points:
    51
    Location:
    Woking, Surrey
    Ratings:
    +44
    if its the same as the 9986, then the component source will need to be set to output Progressive Scan.
     
  3. swedey

    swedey
    Guest

    Products Owned:
    0
    Products Wanted:
    0
    Ratings:
    +0
    Thanks Phil, with perseverence I managed to eventually suss out how to switch it over to progressive scan. Now it works, and the picture is a hell of a lot better than with scart.
     

Share This Page

Loading...