No Sub in Pro-logic II

Discussion in 'AV Receivers & Amplifiers' started by CrispyXUK, Dec 23, 2003.

  1. CrispyXUK

    CrispyXUK
    Active Member

    Joined:
    Feb 5, 2003
    Messages:
    3,751
    Products Owned:
    0
    Products Wanted:
    1
    Trophy Points:
    71
    Location:
    Land of the Living, Essex
    Ratings:
    +45
    Erm for some reason my amp has stopped outputting anything to the sub in PLII mode even though sub volume is set to 0, if I change to DTS/NEO:6 I get sub action.

    Any ideas?
     
  2. Electric Mayhem

    Electric Mayhem
    Well-known Member

    Joined:
    Mar 16, 2001
    Messages:
    10,465
    Products Owned:
    0
    Products Wanted:
    0
    Trophy Points:
    136
    Location:
    United Kingdom
    Ratings:
    +1,941
    Rather odd.:confused: Doublecheck the Channel Levels (SW) but the Denon usually classes PL2/DTS Neo etc as one format. The only thing I can suggest is to do a processor reset which means holding the PCM and AUTO buttons on the front panel whilst turning the Power ON (the display will flash and reset everything). If you do this then write down ALL your settings beforehand i.e Channel Levels, Delay Distances, Digital In Assignments etc so you can key them back in again quickly.
     
  3. CrispyXUK

    CrispyXUK
    Active Member

    Joined:
    Feb 5, 2003
    Messages:
    3,751
    Products Owned:
    0
    Products Wanted:
    1
    Trophy Points:
    71
    Location:
    Land of the Living, Essex
    Ratings:
    +45
    cheers mate will give it a go
     

Share This Page

Loading...
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice