1. Join Now

    AVForums.com uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

nec projector (again) f8 code ?

Discussion in 'Projectors, Screens & Video Processors' started by grahamricho, Sep 15, 2002.

Thread Status:
Not open for further replies.
  1. grahamricho

    grahamricho
    Active Member

    Joined:
    Oct 29, 2001
    Messages:
    658
    Products Owned:
    0
    Products Wanted:
    0
    Trophy Points:
    18
    Location:
    York
    Ratings:
    +12
    set up the projector using the manual and the pic was very good !then after 1 hour 15 mins it turned it self off ! the two digit display is flashing a f8. it will start again if you leave it a while . does anybody no what i asume fault code f8 is ? i am a tv service engineer so im ok fault finding but never touched a crt projector before?many thanks where can i get a service manual for the 6pg projector ? im going to ring round tommorrow my usual suppliers, but i think they only do tv/video diagrams.....thanks g
     
  2. helipilot

    helipilot
    Active Member

    Joined:
    Sep 20, 2001
    Messages:
    314
    Products Owned:
    0
    Products Wanted:
    0
    Trophy Points:
    18
    Location:
    Hamilton
    Ratings:
    +19
    C DRIVE PWB failure places the projector into the standby mode with with the rear control panel LEDs displaying F8.

    I believe this error occurs when the convergence board has a problem.
     
Thread Status:
Not open for further replies.

Share This Page

Loading...