Mounting for mt3

Discussion in 'Projectors, Screens & Video Processors' started by jork40, Oct 11, 2001.

  1. jork40

    jork40
    Guest

    Products Owned:
    0
    Products Wanted:
    0
    Ratings:
    +0
    Can anyone help with some advise to ceiling mounting a Tosh Tlp-Mt3 and how many threaded holes are there on the base cos I only saw 2 is there another 2 under the round rubber feet
    cheers
     
  2. Paul D

    Paul D
    Well-known Member

    Joined:
    Dec 27, 2000
    Messages:
    2,784
    Products Owned:
    1
    Products Wanted:
    0
    Trophy Points:
    136
    Location:
    Manchester
    Ratings:
    +551
    The MT1 (same case) has two screw holes on the "bottom"(towards the front), and two screw holes at the "back"(rear facing etc) of the projector.
    I was suprised how small the screwholes where. You do not have to remove the rubber feet!. ;)
     

Share This Page

Loading...
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice