adam22
Novice Member
Hello
Can anyone help?!
I have recently had a cctv system installed that uses the Labgear HDMX60K to send the image to a tv downstairs.
It all works fine but after a good few hours the image isn't displayed on the TV.
It seems to be after the TV Is turned off, but not always.
The link light is on solid.
If I press the reset button the image is again displayed.
Is there some kind of standby mode after hours of no use?
The instructions are not very detailed.
Any help would be greatly apreciated.
Thanks
Can anyone help?!
I have recently had a cctv system installed that uses the Labgear HDMX60K to send the image to a tv downstairs.
It all works fine but after a good few hours the image isn't displayed on the TV.
It seems to be after the TV Is turned off, but not always.
The link light is on solid.
If I press the reset button the image is again displayed.
Is there some kind of standby mode after hours of no use?
The instructions are not very detailed.
Any help would be greatly apreciated.
Thanks