Iscan pro scaler problem

Discussion in 'Projectors, Screens & Video Processors' started by scott33b, Dec 4, 2004.

  1. scott33b

    scott33b
    Standard Member

    Joined:
    Aug 3, 2004
    Messages:
    68
    Products Owned:
    0
    Products Wanted:
    0
    Trophy Points:
    8
    Ratings:
    +2
    Hi. Can anyone help with a problem??. When the Iscan is set to RGB I get an offset band about 6" wide at the top of the screen, which I can only describe as a squiggle. When I switch the Iscan to YPbPr the picture is perfect except it is very green.
    The Iscan Pro is second hand, but in excellent condition.
     
  2. BertM

    BertM
    Standard Member

    Joined:
    Oct 3, 2004
    Messages:
    41
    Products Owned:
    0
    Products Wanted:
    0
    Trophy Points:
    6
    Ratings:
    +0
    You could try to set the synch signal to a different type, it's now probably set to Bi-Level or Tri-Level, set it to composite or any of the H/V options.
    (Output Setup -> Sync Type)

    Good luck!
    Bert
     

Share This Page

Loading...
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice