Is there a known Multi-Region Hack for the Denon DVD m330?

[weirj535]

Hi,

I am looking for a Multi-Region Hack for the above model, but it doesn't seem to exist. Not sure if its the same firmward as Denon ADV-500SD mention on the forum here.

Any help or suggestions gratefully received!

J

 

[Andy98765]

According to www.vcdhelp.com "check DVD Hacks" it is the same as a DN-V300. Read all.

Region code hack posted by Bob, April 26 2005:
Region Free for an NTSC TV
1. Turn the unit on.
2. Press the “OPEN/CLOSE” button and open the tray.
(Keep the tray open during the setting.)
3. Press “CLEAR” “1” “4” “7” “0” “CLEAR” - “TEST MODE”
will appear on the display.
4. Press the “▲”cursor key and “00 XX” (XX=this will be a
numerical value) will appear on the display. The first
two digits are incremented by one, every time you
press “▲”
5. Press the “▲”cursor key until you see 12 XX (default
is 24) on the display. Press “2” 3” on the remote then
the “ENTER” button
6. Press the “▲” cursor key again and you will see 13 XX
(default is 23). If it does not say “23”,
Press “2” “3” on the remote and then the “ENTER”
button
7. Press the “▲” cursor key again and you will see 14 XX
default is 01). Press “0” “0” on the remote and
then the “ENTER” button.
8. Press “RETURN”
9. Press “CLEAR” twice
10. Press “RETURN” (END should appear on the display)
11. Press the “OPEN/CLOSE” button to close the tray.

Region Free for a PAL TV
If you have a PAL TV follow all the steps but use “33” instead of 23 in steps 5 and 6






Region code posted by Bob, April 26 2005:
For the previous hack “&#9650" should be the "up" arrow on the cursor.




Region code hack posted by videoguru, April 26 2005:
This is the correct hack:
Region Free for an NTSC TV
1. Turn the unit on.
2. Press the “OPEN/CLOSE” button and open the tray.
(Keep the tray open during the setting.)
3. Press “CLEAR” “1” “4” “7” “0” “CLEAR” - “TEST MODE”
will appear on the display.
4. Press the “up”cursor key and “00 XX” (XX=this will be a
numerical value) will appear on the display. The first
two digits are incremented by one, every time you
press “up”
5. Press the “up”cursor key until you see 12 XX (default
is 24) on the display. Press “2” 3” on the remote then
the “ENTER” button
6. Press the “up” cursor key again and you will see 13 XX
(default is 23). If it does not say “23”,
Press “2” “3” on the remote and then the “ENTER”
button
7. Press the “up” cursor key again and you will see 14 XX
default is 01). Press “0” “0” on the remote and
then the “ENTER” button.
8. Press “RETURN”
9. Press “CLEAR” twice
10. Press “RETURN” (END should appear on the display)
11. Press the “OPEN/CLOSE” button to close the

 

[weirj535]

Thanks Andy98765

I Tried the instructions - same as here but No Joy. Region 1 DVD's are still rejected :-(

Is there a reset to default? Any other suggestions?