is it possible to biwire the front main speakers on denon 3802

Discussion in 'AV Receivers & Amplifiers' started by mick23, Apr 3, 2002.

Tags:
  1. mick23

    mick23
    Standard Member

    Joined:
    Mar 20, 2002
    Messages:
    801
    Products Owned:
    0
    Products Wanted:
    0
    Trophy Points:
    18
    Location:
    uk
    Ratings:
    +2
    on my 3802 i am using (a) for pair of surrounds and a pair of rear speakers can i biwire the front main speakers i was told a can run 2 pairs of cables to the the front speaker terminals but i am a bit concerned in trying this thank you
     
  2. bob007

    bob007
    Guest

    Products Owned:
    0
    Products Wanted:
    0
    Ratings:
    +0
    I had a pair of M73's by-wired a while ago, no problem.
     
  3. rnjones

    rnjones
    Guest

    Products Owned:
    0
    Products Wanted:
    0
    Ratings:
    +0
    Mick this shouldnt be a problem. I have Mission 753s bi wired from my AVC-A11SR. Basically at the speaker end you bi wire (leaving off the connector between the posts on the speaker) and connect both + (red) wires and both - (black) wires at the 3802 end. I made a mistake once of reversing some cables and high and low ranges were out of phase. Very strange sound.

    Otherwise I cant think of a reason not to do this.
    Rog
     

Share This Page

Loading...
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice