How to flash AV32R-DP after changing the flash?

stef1777

Standard Member
Joined
Jan 4, 2006
Messages
121
Reaction score
1
Points
17
Hello!

I changed the Flash of my AV32R-DP. It was broken with error 1 at boot.

Does somebody know how to reload the code in the DP after that? I tried to load 4.1 firmware with the UpgradeWizard 2.25 but I got an error.

Thanks for your help.

Stephane
 
Hi,

From the FAQ the error is:

Error 1 - EPROM Failure
Cursory checksum of software failed.
FLASH probably needs replacing.

However if this is the result of flashing the unit, it might be a bad flash.

Previously my "DTS fix" flash went unexpected and I had trouble. Link. However maybe just stubornly reflashing did the trick back then.

I assume you tried to reflash again?

Greetings

Benzol
 
Yes, this is after Flash replacement. The unit was doing Error 1 all the time and I changed it for an AMD.

Not found a way to reflash the unit. The flash is new and seems well soldered. The problem is may be not with the new flash. I discovered a problem with the digital PSU too. Voltages start at 5v at boot and after 2 minutes goes up at +5.3v/-5.5v. Not nice.

I've sent it to Kevin as the unit seems to have multiple breakdown, and without schematics the digital part in close to impossible to repair.

Where did you find the Shark DSP Flasher software?

Stéphane
 
Hello Stef,

this has been posted in the forums. See link. You will have to PM Steve.

Cheers

Benzol
 
Thanks. I'll contact Steve.

The AV32R-DP is back. It was only a problem with the new flash (some pins not well soldered). Unfortunaly, license has been lost. I'm battling with IAG to have then restored. Still waiting for an answer from them...
 

The latest video from AVForums

TV Buying Guide - Which TV Is Best For You?
Subscribe to our YouTube channel
Back
Top Bottom