1. Join Now

    AVForums.com uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Harmony 885 and Arcam AVR300

Discussion in 'Home Cinema Control & Remote Controls' started by GarethL, Oct 22, 2005.

Tags:
  1. GarethL

    GarethL
    Guest

    Products Owned:
    0
    Products Wanted:
    0
    Ratings:
    +0
    I am trying to get a function listed in my Arcam AVR300 manual's IR Remote Codes section working with my Harmony 885.

    The manual says the codes are based on the Phillips RC-5 standard.
    The commands I want to add are

    System Code 16 command Code 16
    System Code 16 command Code 17

    How knowing the codes do I then program them into the Harmony.
    They are not available as selections when setting up the AVR300 on the Harmony, thay are also not available on the original remote control to program from.

    Any help much appreciated.
     
  2. richardbarman

    richardbarman
    Standard Member

    Joined:
    Apr 25, 2005
    Messages:
    65
    Products Owned:
    0
    Products Wanted:
    0
    Trophy Points:
    8
    Ratings:
    +1
    System address 16 is set aside for 'pre-amplifiers' and codes 16 and 17 for vol+ and vol-. Chances are that if you put in some spurious bit of Philips pre-amplifier kit into the harmony set-up, and use the volume up and down commands, the codes will work.

    Richard
     
  3. rowan_moor

    rowan_moor
    Guest

    Products Owned:
    0
    Products Wanted:
    0
    Ratings:
    +0
    Alternatively just email what you posted here to Harmony support and they will add it for you.
     

Share This Page

Loading...