Eclipse 470 problem

Discussion in 'Projectors, Screens & Video Processors' started by john crosley, Oct 1, 2002.

Thread Status:
Not open for further replies.
  1. john crosley

    john crosley
    Guest

    Products Owned:
    0
    Products Wanted:
    0
    Ratings:
    +0
    I've had several prolems with this projector which I have managed to fix (EHT & tube heater voltages) but now I have another. While adjusting the picture size the picture blanked out & the letter E is now permanently showing on the remote display. This normally shows channel number, video mode etc. Does anyone know the meaning if any of the letter E ?
     
  2. Roland @ B4

    Roland @ B4
    Active Member

    Joined:
    Apr 11, 2001
    Messages:
    2,238
    Products Owned:
    0
    Products Wanted:
    0
    Trophy Points:
    51
    Location:
    Reading.
    Ratings:
    +32
    Over size protection by the sound of it. Which cuts in to protect the draw on the power supply.
    Try selecting a different source and see if it will allow you to adjust the size back.
    If it is a PC you are using then up the resoloution which should force the size to reduce anyhow.

    Not sure of the specific E message
     
Thread Status:
Not open for further replies.

Share This Page

Loading...
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice