Help needed please on HC setup: AMP: Yamaha DSP-AX620 DVD: Toshiba SD-210EB TV: Toshiba 32Z13B I 'was' going to do the following: 1 - connect DVD to TV @ SCART to SCART (for video) 2 - connect DVD to AMP @ OPTICAL to OPTICAL (for audio) but 3 - the Yamaha AMP diagrams show COMP-VID out from DVD to COMP-VID in on AMP, then COMP-VID (MON OUT) on AMP to COMP-VID in on TV. Query........ if I do 1 + 2, I won't see the AMP setup menus on the TV; is this a problem with the Yamaha DSP-AX620? is it worth putting the DVD video signal through the AMP? if I do 3 I'd have to use a SCART on the TV as it doesn't have COMP-VID input. would this work? or would using S-VID from AMP to TV SCART be better? \_\_\_\_\_\_\_\_\_\_\_\_\_\_\_\_\_\_\_\_\_\_\_\_\_\_\_\_\_\_ if I add a VCR to the mix (Sony SLV-SE800G): would I benefit replacing the low 'spec' AERIAL-coax-VCR-coax-TV connection with an AMP-VCR-AMP setup using PHONO for audio in/out and for video in/out using SCART (VCR) to PHONO (AMP) or SCART (VCR) to S-VID (AMP) conversion leads? also, would aerial RF input go to TV or VCR (I suspect the latter)?