Question Dolby Atmos Height 2 pre out/zone 2 confusion

Discussion in 'AV Receivers & Amplifiers' started by Gruntfuttock, Aug 25, 2018.

  1. Gruntfuttock

    Gruntfuttock
    Active Member

    Joined:
    Nov 20, 2007
    Messages:
    211
    Products Owned:
    0
    Products Wanted:
    0
    Trophy Points:
    18
    Ratings:
    +12
    I have a Denon AVR-X4300H, I am about to set up 7.1.4. Height 2 speakers will run from height 2 pre-out to separate stereo amp. I already have height 2 speaker terminals in use, assigned ZONE 2.
    My question is, can I leave the speaker terminals connected? When I change my settings to 7.1.4 will I still be able to use ZONE 2 when Atmos is not in use? Will I have to go back into settings to re-assign ZONE 2?
    I know this may all be obvious but I wanted to double check before I wire it up.
    Any help would be very much appreciated.
    Thank you
     
  2. Gruntfuttock

    Gruntfuttock
    Active Member

    Joined:
    Nov 20, 2007
    Messages:
    211
    Products Owned:
    0
    Products Wanted:
    0
    Trophy Points:
    18
    Ratings:
    +12
    Well anyway......
    I set it up and zone 2 doesn’t work, cables still attached to height 2 speaker terminals and 7.1.4 works fine
     

Share This Page

Loading...