Denon POA T10 and Tannoy Fusion 3's

Discussion in 'AV Pre-Amp/Processors & Power Amps' started by octo, Mar 11, 2006.

  1. octo

    octo
    Guest

    Products Owned:
    0
    Products Wanted:
    0
    Ratings:
    +0
    Im putting together a hifi system. Planning on coupling a "Denon POA T10 Power Amplifier" and Tannoy Fusion 3 floorstanding speakers.

    Dont know too much about about this kind of stuff...What do you think?

    Specs....
    (Amp)
    [​IMG]

    (Speakers)

    PERFORMANCE
    Recommended amplifier power 10 -100 Watts RMS
    Continuous power handling 70 Watts RMS
    Peak output power 140 Watts
    Low frequency response 32Hz
    Sensitivity 89dB
    Nominal impedance 8ohms
    Frequency response 35Hz - 20kHz
    DRIVE UNITS
    High frequency 25mm(1") Nitro-Urethane layer damped woven polyester dome, shielded neodymium magnet assembly
    Low frequency 165mm (6.5") coated multi-fibre paper pulp cone
    CROSSOVER
    Frequency 2.7kHz (Bi-wireable)
    Type 4th order acoustic linkwitz-riley

    Will this sound good?

    A fast response would be great because the auction is ending in about 4 hours!
    Thanks.
     
  2. Nic Rhodes

    Nic Rhodes
    Well-known Member

    Joined:
    Mar 23, 2001
    Messages:
    17,152
    Products Owned:
    0
    Products Wanted:
    1
    Trophy Points:
    133
    Location:
    Cumbria
    Ratings:
    +1,276
    The specs will tell you nothing however the amp is a decent one and I have installed it in more than one friends system. All down to price. It will drive most speakers reasonably well.
     
  3. octo

    octo
    Guest

    Products Owned:
    0
    Products Wanted:
    0
    Ratings:
    +0
    Thanks for the reply. I just called richersounds and a guy there said you cant use this amp as a standalone amp and that it wouldnt do anything without a pre-amp...Is this right? The amp has got no volume control or anything so im guessing hes right. Just want to double check with you lot first though.
     
  4. Nic Rhodes

    Nic Rhodes
    Well-known Member

    Joined:
    Mar 23, 2001
    Messages:
    17,152
    Products Owned:
    0
    Products Wanted:
    1
    Trophy Points:
    133
    Location:
    Cumbria
    Ratings:
    +1,276
    Yes that is right, it is a power amp that has been designed to connect to the pre out from a pre amp / AV receivers, both of which do the volume (switching etc).
     
  5. octo

    octo
    Guest

    Products Owned:
    0
    Products Wanted:
    0
    Ratings:
    +0
    Ok thanks for the help mate.
     
  6. octo

    octo
    Guest

    Products Owned:
    0
    Products Wanted:
    0
    Ratings:
    +0
    So what amp would you reccomend for Tannoy Fusion 3's? Preferably under £160?
     
  7. Henry

    Henry
    Active Member

    Joined:
    Aug 9, 2000
    Messages:
    2,194
    Products Owned:
    0
    Products Wanted:
    0
    Trophy Points:
    51
    Location:
    Hull
    Ratings:
    +52

Share This Page

Loading...