Bi-amping speakers (Denon 2807)

Discussion in 'AV Receivers & Amplifiers' started by jwyg, Feb 4, 2009.

Tags:
  1. jwyg

    jwyg
    Active Member

    Joined:
    Jan 16, 2009
    Messages:
    373
    Products Owned:
    0
    Products Wanted:
    0
    Trophy Points:
    18
    Ratings:
    +8
    hi, i've recently bought a 2nd hand AVR2807 and some tannoy F4 speakers. reading the manual, it appears that i can bi-amp the front speakers on a 5.1 set-up by using the surround rear outputs (at least i think it was surround rear, i got a bit confused by the front A+B thing)

    However, it mentions nothing on the manual about which speaker outputs should go to the high frequency input on the speaker, and which to the low - or does the amp not split high and low frequencies?
     
  2. Peter Galbavy

    Peter Galbavy
    Guest

    Products Owned:
    0
    Products Wanted:
    0
    Ratings:
    +0
    Doesn't matter. The frequencies are "selected" by the speaker / high and low pass filters in the speaker.
     
  3. jwyg

    jwyg
    Active Member

    Joined:
    Jan 16, 2009
    Messages:
    373
    Products Owned:
    0
    Products Wanted:
    0
    Trophy Points:
    18
    Ratings:
    +8
    ok great cheers - asking as with my audio amp i could bi-wire and this split high and low freq's but i'll be replacing this with the denon.
     

Share This Page

Loading...