Barco 600-s vision

  • Thread starter my_name_is_nobo
  • Start date
M

my_name_is_nobo

Guest
hy Im from sweden and need some help on Barco 600-s vision somthing has happend when i was tryibng to perfect the convergence suddely the picture died now i cant get it back the projector sound like before but have no picture. its like when the control box is off on the back. is there any fuses that have gone ? or what please help
have had many good moment on this projektor dont want to get new
regards marcus
 
L

ledoctt

Guest
hi marcus , you have a board with led light could you tel me the state of her??
Do you have a red led Scan fail SF lignhting??

[email protected]
 
M

my_name_is_nobo

Guest
Hi hi Well the only led lights are on the focus were there is 6 green lights and one yellow when its on pattern mode when its turn on to video the yellow is turnd of .
The is a green led on one of the circit bourd but i dont know if it was there before
gretaful for ansewer
regards
marcus
 
L

ledoctt

Guest
hi if there are no led red lighting on board focus "scan fail" and led eht hold down on the board hor deflexion &eht...

you can verificated the two fuses on board subunit of your sm power suplly F4 et F5 4ampéresT become 5 AT..
After you must verificated SR 34 on the board sometimes the resistor will cutted, you must remplaced it by fuse to sold 0.5A slow....
the resistor it's near the transfo eht 774128

[email protected]
 
Top Bottom