1. Join Now

    AVForums.com uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

Avr-250

Discussion in 'Arcam Owners' Forum' started by @TOMMY@, Aug 19, 2005.

  1. @TOMMY@

    @TOMMY@
    Standard Member

    Joined:
    Aug 19, 2005
    Messages:
    11
    Products Owned:
    0
    Products Wanted:
    0
    Trophy Points:
    1
    Ratings:
    +0
    1. When bi-amping, does it matter if I use the main L/R channels to drive the high frequency and 6/7th channels to drive the low frequency? or can I do it the other way around (because all channels should have the same amplification right?)

    2. My speaker wire has 8 smaller wires. My dealer suggests it would be better if I use 2 to bi-wire the high frequency and 6 to the low frequency. What would be the difference if I just use 4 and 4 instead of 2 and 6.
    Thank you
     
  2. Hifi addict

    Hifi addict
    Guest

    Products Owned:
    0
    Products Wanted:
    0
    Ratings:
    +0
    1. haven't heard any difference and the amps should be the same

    2. depends on the speakercable you have. Best is to try and listen yourself. In theory, bas needs more energy/wires so that's why he suggested 6-2, but again depending on the quality of your cable, you should try 4-4 as well
     
  3. @TOMMY@

    @TOMMY@
    Standard Member

    Joined:
    Aug 19, 2005
    Messages:
    11
    Products Owned:
    0
    Products Wanted:
    0
    Trophy Points:
    1
    Ratings:
    +0
    OK thank you very much. I shall try that :thumbsup:
     

Share This Page

Loading...