1. Join Now

    AVForums.com uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

AVR-250 sub setup

Discussion in 'Arcam Owners' Forum' started by blitzschnell, Dec 20, 2004.

  1. blitzschnell

    blitzschnell
    Guest

    Products Owned:
    0
    Products Wanted:
    0
    Ratings:
    +0
    Hi,

    I'm a bit confused in setting up speaker config on my avr-250.
    I feel like there should be at least two cross over frequency parameter. One
    for setting the the 'small' speaker crossover point and one for using the
    setting Stereo Mode : LARGE+SUB. My large front speaker can go
    down to 35 while my center and rear can only reach 70 Hz.
    Utltimately I think there should be 4 crossover; 1 for front 1 for rear 1 for center and 1 for surround back. That way, it would be clear what frequency is going where.

    I dont think it would need much power from DSP, I would accept to trade the bass/treble adjustement for the crossover setting.
     
  2. Crustyloafer

    Crustyloafer
    Well-known Member

    Joined:
    Sep 12, 2003
    Messages:
    9,502
    Products Owned:
    0
    Products Wanted:
    0
    Trophy Points:
    136
    Location:
    Edinburgh
    Ratings:
    +1,237
    You should have gone for a Harman Kardon receiver then, they have individual crossover settings for every channel.
     

Share This Page

Loading...