Anyone using a Draper Baronet electric screen with IR control?

Discussion in 'Projectors, Screens & Video Processors' started by Messiah, Jul 20, 2002.

  1. Messiah

    Well-known Member

    Apr 22, 2002
    Products Owned:
    Products Wanted:
    Trophy Points:
    If so, are you able to advise which of the three IR control wires go into which connectors on the control box.

    I have fitted my screen today and completed the wiring but the unit is absolutely dead. There is 240V going into the control box and the fuse in the box is good. The IR sensor has 3 wires from it, blue, white and yellow but the instructions and the markings on the PCB connectors refer to the wires as C, Si and +. No mention of colours.

    Can anyone help out here. BTW, I have not fitted and do not want to fit the manual switch. I am assuming (nothing in the install sheets) that I can use just the IR control with no switch or am I wrong here.


Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice