Deleted member 134693
- Joined
- Jun 13, 2006
- Messages
- 13,523
- Reaction score
- 3,413
- Points
- 3,158
Hi,
I was reading a post on an American forum in the Bowers & Wilkins section and someone had replaced the cables inside a set of B&W 703 speakers and said the results where amazing. A few other people on the forum has also said they'd done the same with excellent results including changing plugs/binding posts to higher quality stuff. They did a side by side comparison of the cables and they one they had used was much thicker than the standard B&W cables.
Has anyone on here tried upgrading their cables/binding posts etc inside there speakers and did they get any improvement.
If not do you think it would give an improvement. It seems a little daft spending tens of thousands developing drivers/enclosures etc and then skimping on 18" of cable inside a speaker
If its worth doing I might try it but, although taking some £1600 speakers apart is a little daunting to say the least
I was reading a post on an American forum in the Bowers & Wilkins section and someone had replaced the cables inside a set of B&W 703 speakers and said the results where amazing. A few other people on the forum has also said they'd done the same with excellent results including changing plugs/binding posts to higher quality stuff. They did a side by side comparison of the cables and they one they had used was much thicker than the standard B&W cables.
Has anyone on here tried upgrading their cables/binding posts etc inside there speakers and did they get any improvement.
If not do you think it would give an improvement. It seems a little daft spending tens of thousands developing drivers/enclosures etc and then skimping on 18" of cable inside a speaker
If its worth doing I might try it but, although taking some £1600 speakers apart is a little daunting to say the least