1. Join Now

    AVForums.com uses cookies. By continuing to use this site, you are agreeing to our use of cookies. Learn More.

amp JBL755.6 problem!

Discussion in 'ICE, Sat Navs & Dash Cams Forum' started by scoobystan, Aug 6, 2005.

  1. scoobystan

    scoobystan
    Guest

    Products Owned:
    0
    Products Wanted:
    0
    Ratings:
    +0
    just installed a brill system into my car today, saved mesef £200 fr a job i put just as much time and effort into completing.
    Gone to power up system and amp has no power?!
    checked the earth and power suppy with a volt meter and both are fine, can ony think its the amp which is busted (its brand new out of the box) or the remote cable not connected correct, any ideas??
     
  2. lynx

    lynx
    Well-known Member

    Joined:
    Jan 20, 2002
    Messages:
    4,633
    Products Owned:
    0
    Products Wanted:
    0
    Trophy Points:
    106
    Location:
    It always rains.
    Ratings:
    +301
    Run a short length of wire from the +ve to the rem terminal,that should now energise the start up realy and power up the amp.Don't leave the amp like this as it won't power down and a drained battery will result.
     

Share This Page

Loading...