Tommy2020
Novice Member
Hi Everyone,
I'm new to this forum and after some help so hopefully I have posted in the correct thread.
Over the past few weeks my Altec Lansing AD A885 speaker system has stopped working. I have removed and re-seated all the cables and up to the point of it not working I used the green front cable to connect this to my tablet and laptop and worked fine. The diags button on the sub woofer works and goes through all speakers.
Holding down the mode button does not produce any out put when the display changes to noise which the manual says it should.
Its obviously a old system but the sound is great so really want to figure out what the issue is.
Any ideas? Thanks.
I'm new to this forum and after some help so hopefully I have posted in the correct thread.
Over the past few weeks my Altec Lansing AD A885 speaker system has stopped working. I have removed and re-seated all the cables and up to the point of it not working I used the green front cable to connect this to my tablet and laptop and worked fine. The diags button on the sub woofer works and goes through all speakers.
Holding down the mode button does not produce any out put when the display changes to noise which the manual says it should.
Its obviously a old system but the sound is great so really want to figure out what the issue is.
Any ideas? Thanks.