grunviz
Established Member
- Joined
- Apr 19, 2006
- Messages
- 557
- Reaction score
- 128
- Points
- 196
I am doing some research looking for some advice regarding whether I could consider adding a subwoofer to my 2 channel set-up. I don’t necessarily need a sub, but I do like tinkering with my system so I am looking at options in terms of placement and then, when and if appropriate, possible kit.
A word on my current set-up; I am a Roon user, with a hardwired system. I have an Intel NUC running the Roon software, and this feeds a raspberry pi 4 running ropieee over Ethernet which provides an input into my Topping D90 DAC via USB. The DAC feeds my Musical Fidelity M6si amplifier which feeds my Kef Reference 1 speakers.
I have a relatively small room (see attached schematic for size measurements) that is irregular in shape, the room doubles as my listening room and office. I have previously measured my room acoustically to create digital correction filters and I have also attached those results. And for good measure, I have included a photo too!
My initial question is around potential placement, and in the schematic I have marked some possible locations for a sub – see numbered boxes. Are there any thoughts, positive or negative, as to these possibilities? I can shift kit around if needs be.
Finally, are there any thoughts on kit that might be a good match?
A word on my current set-up; I am a Roon user, with a hardwired system. I have an Intel NUC running the Roon software, and this feeds a raspberry pi 4 running ropieee over Ethernet which provides an input into my Topping D90 DAC via USB. The DAC feeds my Musical Fidelity M6si amplifier which feeds my Kef Reference 1 speakers.
I have a relatively small room (see attached schematic for size measurements) that is irregular in shape, the room doubles as my listening room and office. I have previously measured my room acoustically to create digital correction filters and I have also attached those results. And for good measure, I have included a photo too!
My initial question is around potential placement, and in the schematic I have marked some possible locations for a sub – see numbered boxes. Are there any thoughts, positive or negative, as to these possibilities? I can shift kit around if needs be.
Finally, are there any thoughts on kit that might be a good match?