50PUS7394/12 died , Software problem I think

johntee50

Active Member
Upgraded the software to the latest one a few weeks ago over the internet. Had problems with it from day one. Wouldn't always boot on first attempt, when it did finaly boot it wouldn't open the tv channels unless I selected a different channel to the one I left it on. Tried a reinstal tv, but no improvement. yesterday it screwed up completely. Turned it on and it booted halfway then went to the apps home screen instead of a tv channel. tried a reinstall again, but it won't do it. I just get a spinning circle forever. It worked a little, so I downloaded the latest software from Toengel and tried to reinstal it. Goes through the process, but is exactly the same. on checking, I find it's in shop mode and won't come out of it. Any suggestions for rescue software ? I tried the Toengel downgrade software, but it doesn't seem to instal. Goes through the process, but the set is still the same.

Regards to all, JT
 

The latest video from AVForums

Panasonic LZ2000, LZ1500 & LZ980 Hands-on Launch Event | No QD-OLED for 2022, new 77-inch for LZ2000
Subscribe to our YouTube channel
Support AVForums with Patreon

Top Bottom