42PX60 Problem

Discussion in 'Plasma TVs Forum' started by mad_angler1, Sep 7, 2007.

  1. mad_angler1

    mad_angler1
    Active Member

    Joined:
    Aug 17, 2006
    Messages:
    204
    Products Owned:
    0
    Products Wanted:
    0
    Trophy Points:
    18
    Ratings:
    +4
    Hi guys I have a small issue with my Panasonic 42PX60, every time I turn it on from standby it comes on analogue TV(which I don’t have) I have set power on preference to AV but it still comes on channel 1, any ideas? It used to be fine,

    I only have it connected by HDMI.
     
  2. Boxinghris

    Boxinghris
    Active Member

    Joined:
    Aug 25, 2003
    Messages:
    565
    Products Owned:
    0
    Products Wanted:
    0
    Trophy Points:
    46
    Location:
    Lancashire
    Ratings:
    +183
    I have this problem too and it's a pain in the arse.

    Perhaps Panasonic incorporated this fault into the PX60 to distract us from the purple snakes?:rolleyes:
     
  3. WGLOVER

    WGLOVER
    Active Member

    Joined:
    Jun 8, 2006
    Messages:
    1,598
    Products Owned:
    2
    Products Wanted:
    0
    Trophy Points:
    66
    Location:
    Billinge, Wigan
    Ratings:
    +121
    Mine doesn't.
    If I I leave my Virgin+ on standby, the TV starts up with Freeview. Must be a problem with your default settings.

    PS. No snakes. This is a superb TV.
     
  4. mad_angler1

    mad_angler1
    Active Member

    Joined:
    Aug 17, 2006
    Messages:
    204
    Products Owned:
    0
    Products Wanted:
    0
    Trophy Points:
    18
    Ratings:
    +4
    looks like i have sorted it, i did a full reset (shipping condition) but then switched it off at the mains for a few hours, then fired it back up, did all the instalation again and its fine now. i think i needed to power it down before doing the setup again :thumbsup:
     

Share This Page

Loading...