1 wire left.... where does it go?

Discussion in 'ICE, Sat Navs & Dash Cams Forum' started by MrControversial, Aug 7, 2012.

  1. MrControversial

    MrControversial
    Novice Member

    Joined:
    Aug 7, 2012
    Messages:
    8
    Products Owned:
    0
    Products Wanted:
    0
    Trophy Points:
    1
    Ratings:
    +0
    Hi all,

    Just at the final stage of installing and I've stumbled at the last hurdle. Everything connected bar the ignition feed (marked A - red wire). The loom is a little different to my old one so can anyone tell me, from the pic below, if A goes into B or C? As you can see further up, A is cut into the feed before the connection block, I assume this is to bypass the ignition?

    [​IMG]


    This is the last wire, then I just need to figure out if the ISO plug (X) needs to go in Y or Z.

    Hope someone can help. Thanks in advance ;)
     
  2. MrControversial

    MrControversial
    Novice Member

    Joined:
    Aug 7, 2012
    Messages:
    8
    Products Owned:
    0
    Products Wanted:
    0
    Trophy Points:
    1
    Ratings:
    +0
    Sorted! A went to C and X to Z... ruined the seat of my pants in the process but hey, it worked!
     

Share This Page

Loading...
  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice