rf out

In a radio receiver circuit, the RF front end is a generic term for all the circuitry between the antenna up to and including the mixer stage. It consists of all the components in the receiver that process the signal at the original incoming radio frequency (RF), before it is converted to a lower intermediate frequency (IF). In microwave and satellite receivers it is often called the low-noise block (LNB) or low-noise downconverter (LND) and is often located at the antenna, so that the signal from the antenna can be transferred to the rest of the receiver at the more easily handled intermediate frequency.
For most superheterodyne architectures, the RF front end consists of:
A 'gentle' band-pass filter (BPF) to reduce strong out-of-band signals and image frequency response;
An RF amplifier, often called the low-noise amplifier (LNA). Its primary responsibility is to increase the sensitivity of the receiver by amplifying weak signals without contaminating them with noise, so that they can stay above the noise level in succeeding stages. It must have a very low noise figure (NF). The RF amplifier may not be needed and is often omitted (or switched off) for frequencies below 30 MHz, where the signal-to-noise ratio is defined by atmospheric and man-made noise.
A local oscillator (LO) which generates a radio frequency signal at an offset from the incoming signal, which is mixed with the incoming signal.
The mixer, which mixes the incoming signal with the signal from the local oscillator to convert the signal to the intermediate frequency (IF).
In many modern integrated receivers, particularly those in wireless devices such as cell phones and Wifi receivers, the intermediate frequency is digitized; sampled and converted to a binary digital form, and the rest of the processing - IF filtering and demodulation - is done by digital filters (digital signal processing, DSP), as these are smaller, use less power and can have more selectivity. In this type of receiver the RF front end is defined as everything from the antenna to the analog to digital converter (ADC) which digitizes the signal. The general trend is to do as much of the signal processing in digital form as possible, and some receivers digitize the RF signal directly, without down-conversion to an IF, so here the front end is merely an RF filter.

View More On Wikipedia.org
  • 137

    Stuart Wright

    AVForums Founder From Birmingham, UK
    • Messages
      17,040
    • Solutions
      1
    • Reactions
      14,014
    • Points
      7,651
  • 1

    DinoKustas

    Established Member 36
    • Messages
      167
    • Reactions
      6
    • Points
      94
  • 1

    mikeyjg

    Standard Member 50
    • Messages
      4
    • Points
      2
  • 1

    Izza79

    Novice Member 44 From Leeds
    • Messages
      9
    • Points
      2
  • 1

    iaingray741

    Standard Member 41
    • Messages
      19
    • Points
      36
  • 1

    Jolskjaer

    Novice Member 44 From England
    • Messages
      3
    • Points
      1
  • 1

    donnygal

    Standard Member
    • Messages
      20
    • Points
      31
  • 1

    1rtomlinson

    Novice Member 38 From Rossendale
    • Messages
      3
    • Points
      27
  • 1

    mpjtaylor

    Standard Member 49
    • Messages
      33
    • Reactions
      4
    • Points
      11
  • 1

    Varoshiotis

    Novice Member 71 From Wales
    • Messages
      9
    • Points
      28
  • 1

    gabble

    Novice Member 56 From Dumfries
    • Messages
      5
    • Reactions
      1
    • Points
      1
  • 1

    armitage5hanks

    Novice Member 50 From Norfolk
    • Messages
      1
    • Points
      1
  • Back
    Top Bottom